Below Nav Bar Ad Module

Collapse

Announcement

Collapse
No announcement yet.

rear wheel bearings np nm

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • rear wheel bearings np nm

    Hi All
    Has anyone carried out a service check of the rear wheel bearings
    for an NM or NP. The manual asks to inspect bearings ever 45,000 km, The workshop manual dosen't mention it. What's involved ? can it be done
    without special tools.
    regards Garfield

  • #2
    Jack it up and try and wobble the tyre (in various directions) - if it wobbles your in trouble.
    --
    Marquis
    SOLD - NT MY10 DiD, ARB D/Bar, Airtec, LRA 81L, Bil/Lov 2", BCDC1220+AGM, P3

    Comment


    • #3
      I think that they are actually an unservicable sealed hub assembly like the fronts. Never had a spot of bother with those on my NM in 175,000km. Cant say the same for the fronts though that was a known issue.

      A check for run-out and a spin for noise should be all that is required.

      Pat
      2016 Mitsubishi NX Pajero GLX
      2011 Landrover Freelander II SD4

      Comment


      • #4
        Thanks for the info
        egards Garfield

        Comment


        • #5
          My fronts need replacing at 90k service. Heaps of wobble apparently. Bummer,.
          Pajero Exceed 3.8l, BFG AT 275/70, Narva Ultima 175 spots, o2 Jamin with BT GPS, O'Briens camping trailer, 2" Lift with Bilsten Shocks.

          Comment


          • #6
            Early front ones are well known to fail. But yours is a later NP - they were supposed to have a slightly revised hub by then?

            Pat.
            2016 Mitsubishi NX Pajero GLX
            2011 Landrover Freelander II SD4

            Comment

            Matched content

            Collapse
            Working...
            X