vladguan
Valued Member
Last Activity: 3 hours ago
Joined: 04-03-15
Location: Adelaide
-
Map sensors has been known to cause those lights to come on as does faulty battery/alternator. -
Leave a comment:
-
Just accepted you in my group. Have a read of the announcement post. Also, are you on the south American pajero experience FB group?Leave a comment:
-
Could be a ballast issue.Leave a comment:
-
The answers to my FB groups are: NS to NX for gen 4 and NM to NP for gen 3.
As for which wires, there is actually just two. I miss read the diagram. The pins are #83 and #84 of the right-most plug of the ASTC ECU (the one that my loom replaces)....Leave a comment:
-
The ASTC ECU (active stability and traction control) controls the behaviour and it sends a signal to the engine ECU to cut power. It has four wires connected to the engine ECU. I guess you could permanently cut those wires but the Engine ECU may go into...Leave a comment:
-
And have that person standing on the side of the car especially if selecting D and watch where they place their feet....Leave a comment:
-
There is no way to prevent it cutting power as it is all controlled by the ASTC ECU. However, you can turn it off with my traction control mod loom which tricks the ASTC ECU into thinking the rear diff lock is on (the only time TC is off by default)....Leave a comment:
-
Will do that when I have the time to go through the pages....Leave a comment:
-
Cheers. I completely missed the Edit post signature line....Leave a comment:
-
The issue is with the width. 285mm is not recommended for 7.5" wide rims. Minimum recommended rim width is 8". 275/70R17 is suitable and is 32" in old terminology.Leave a comment:
-
How to edit a signature
Hi Admins,
How do I edit my signature to change the link to the new URL? -
The sensors were bought on eBay. Glass break sensor is the DEI-506T and the tilt sensor is the DEI-507M. I used standard relays and latching relays as well as a timer relay to hook them all up. When the sensors are activated, they ground the back door...Leave a comment:
-
If it is the 3.8 V6 then it is obd2 compliant and the bluetooth ELM327 OBD 2 dongles should work with them.Leave a comment:
-
I replaced the powder coated steel brackets for my ocam awning with carinya brand 304 ss brackets from bunnings. Way better. Just had to drill out an additional hole to line up with the channels on the back of the awning.Leave a comment:
-
Is yours a diesel?Leave a comment:
-
I fabricated my own recovery board holder and fishing rod holder using 5mm angled and flat aluminium bars. Had them fit over cross bars via t-bolts into the channels.Leave a comment:
-
Rudi, aka Mr Pajero in WA makes and sells the subframe drop kit.Leave a comment:
-
Search for what I did to augment the base security system. The Exceed came with intrusion sensors and tilt sensors. The others only activate the alarm if the doors and bonnet were opened. Are you sure your alarm has been activated? Do you have a blinking...Leave a comment:
-
One thing I found to ease the itchiness is aquim hand sanitisers.Leave a comment:
No activity results to display
Leave a comment: